• Continuous, uniform light output, similar to appearance of traditional neon lights, yet much more energy-efficient
• Outputs brilliant colors when used with compatible RGB controller
• Water-resistant (IP67), flexible (may be gently bent up-and-down), continuous length of 16.4 feet (5 m)
• Cuttable every ~2 inches at designated cut marks to fit various length requirements
• Wires on both ends, allowing it to be cut into 2 usable sections

Description

For those that love the look of traditional neon lights but prefer a more flexible and energy-efficient solution, this LED COB neon strip would be a great choice.  Unlike regular neon tubes that are rigid and require periodic refill of neon gas, this LED strip is flexible and long-lasting, and offers the ability to make changes to the line forms any time.  When used with a compatible RGB controller, it can display various colors.

Note

• The power rating printed on the tag of the LED strip is incorrect.  Refer to Specifications table below instead.
• Minimum bending radius: 5cm (2").
• Must be used with 24VDC power source and compatible RGB controller (not included).
• Unroll LED strip completely before powering for long periods of time.
• Unused wires of the LED strip must be isolated.
• Test all components before cutting or permanently mounting the strip.
• Any cuts made to the LED strip should be sealed with silicone caulk or similar product.
• Additional lengths should be wired in parallel (controller and power source must be of adequate capacity).
• For best results, power LED strip from both ends whenever possible.

Specifications