• 140W high power 24V LED strip with 1800 SMD1808
• 32.8-ft long; cuttable every 6 groups of LEDs, approx. every 4", at designated cut marks to suit various length requirements
• Cut sections may be linked by directly soldering wires
• Compatible with a wide range of RGB controllers
• Adhesive back for easy installation on clean, dry, smooth, flat, non-porous surfaces

Description

This high quality, 24-volt, flexible color-changing LED strip is perfect for mood and accent lighting.  The entire roll is 32.8 ft (10 m) in length, and is cuttable and re-linkable. When used with an RGB controller (sold separately) one can control the color output including solid colors (red, green, blue, etc.), gradient fading, and blinking.

Note

• Must be used with compatible power supply and RGB controller.
• Avoid exposure to direct sunlight.
• Minimum bending radius: 5 cm (2").
• Unused wires of LED strip must be isolated to prevent potential short circuit.
• Unroll LED strip completely before powering on.
• Test all components before cutting or permanently mounting the strip.
• Do not lengthen LED strip by directly connecting additional strips to it; additional lengths should be wired in parallel (controller and power supply must be of adequate capacity).
• Due to its high power, it is strongly recommended to mount LED strip on aluminum channels to facilitate proper heat dissipation.

Specifications (LED strip)