Description

This hardware kit is for use with 15x25mm RGB color-changing (4-conductor) flexible LED neon strip lights.  Compatible with product codes 20271RGB and 20272RGB.

Installation (power cable connector)

• If possible, test strip light before cutting it, which would help in troubleshooting if it does not light up after installing connector.
• Check that the strip light is properly cut at one of the designated cut marks (dots on bottom side of strip light).
• Insert pointed end of 4-pin header connector into the conductors of strip light.
• Attach connector of power cable to 4-pin header connector.
• To make the connection water-resistant, silicone caulk or similar product should be used to seal it.

Wiring

• Blue wire to +24VDC of controller
• Red wire to Red of controller
• Black wire to Green of controller
• Green wire to Blue of controller

Specifications